Rikhter R-23


















































































R-23 Aircraft Cannon
Type Single-barrel revolver cannon
Place of origin Soviet Union
Service history
Used by
Soviet Union, Russia
Production history
Designer Aron Abramovich Rikhter
Designed 1964
Manufacturer
Tulamashzavod, Tula

No. built
500+
Specifications
Weight 58.5 kg (129 lb)
Length 1,468 mm (4 ft 10 in)

Barrel length
approx. 1,140mm barrel length
Width 170 mm (7 in)
Height 165 mm (6 in)

Caliber 23 mm (0.9 in)
Barrels 1
Action gas operated revolver
Rate of fire 1,800–2,000 rpm
Muzzle velocity 850 m/s (2,800 ft/s)
Feed system belt

The Rikhter R-23 is an aircraft autocannon developed for the Soviet Air Force starting in the late 1950s. It was designed to be as short as possible to avoid problems found on high-speed aircraft when the guns were pointed into the airstream. The R-23 was a gas operated revolver cannon that used gas bled from holes in the barrel to provide the motive force. Firing up to 2,600 rpm, the R-23 was the fastest firing single-barrel cannon ever introduced into service.


The R-23 took some time to develop, and was not used operationally until 1964. It was used only in the tail turret of the Tu-22, and experimentally on the Salyut 3 space station. Its role was taken over by the twin-barrel Gryazev-Shipunov GSh-23.


A modified version of the weapon was the only cannon to have been fired in space.[1]




Contents






  • 1 Development


  • 2 Mechanism


  • 3 Secrecy


  • 4 Ammunition specifications


  • 5 References


  • 6 See also





Development


In the late 1940s and the early 1950s tests with defensive bomber turret cannons resulted in problems caused by the air flow affecting the weapons' barrel. Among these were the widely used Nudelman-Rikhter NR-23, found in many bomber installations, which barrels that extended far past their mounting points. A contest for a new design that was much shorter led to entries from Aron Abramovich Rikhter at A.E. Nudelman's OKB-16 in Moscow, and a competing design from Igor Dmitriev's TsKB-14 in Tula.[2]


Rikhter's design was radical; he selected a revolver cannon layout, but chose a front-loading design where the rounds were fed rearward into the revolver chambers. This allowed the feed mechanism to be placed in front of the rotating block, under the barrel. This created a gun with shorter overall length, and greatly improved the balance, with the center of gravity almost directly under the middle of the barrel. Despite some initial problems, the first 261-P prototype cannon was produced in 1957. On 7 August 1964 the cannon was adopted and received the official designation R-23. By this time the competing design from TsKB-14 has also been put into production as the Afanasev Makarov AM-23.





Tu-22PD tail turret, showing the radome above it


The R-23 is installed in the DK-20 tail turret of the “A”, “B”, “K” and “R” versions of the Tu-22 bomber only. The hydraulically elevated and traversed DK-20 turret uses the “Krypton” radar sight and TP-1 or TP-1A television sights. Spent cartridge cases are ejected outside the aircraft. The DK-20 turret weighs 593 kg including the R-23 cannon and 500 rounds of ammunition.


A subsequent application found the cannon in the Soviet space program. It was mounted on the military space station ALMAZ/Salyut 3/OPS-2 as a self-defence weapon. At the end of the mission, when the station flew unmanned, it was tested and successfully fired. This "space cannon" had a supply of 32 rounds.



Mechanism


The 23 mm R-23 is a gas-operated revolver cannon. The revolving cylinder has four cartridge chambers. Three separate gas systems are used; one ejects the fired cartridge case from the chamber, another chambers a fresh round, and the last drives the revolver cylinder and the feed mechanism.


In most gun designs, rounds are fed from the rear and rammed forward into the chamber. This leads to the traditional cartridge layout with the bullet or shell at the front, and a tapering cylindrical casing behind it. As the round is pushed forward, the tapering shape of the bullet and casing guides it into the center of the chamber. Rikhter's 261P design did the opposite, feeding the round rearward. To accomplish this, GSKB-398 (today's GNPP “PRIBOR”) designed a round with the bullet completely enclosed in a galvanized steel casing, which was tapered to a bullet-like ogee at the rear and tipped by the electrically-fired primer. The front of the round was open, with the tip of the shell even with the end of the opening. The shell was held into the case by heavy crimping near the end of the shell.[3]


The ammunition is fed from the right side only and consists of a belt that contains the cartridges in disintegrating belt links. The latter drop out on the left side of the receiver. Fired cases are ejected forwards on the right side of the receiver.


The R-23 cannon has an automatic charging mechanism that fires the cannon in case of a misfire. When one of the two pyrotechnical cartridges is fired, a small bolt inside that cartridge is accelerated to penetrate the side wall of the R-23 cartridge. The hot propellant gases of the pyrotechnical cartridge follow the bolt into the dud R-23 cartridge and ignite the propellant charge to fire the round. This unique and curious mechanism was used in the R-23 cannon for the first time. The same kind of mechanism with a single pyrotechnical cartridge was later incorporated into the 30 mm GSh-301 aircraft cannon.



Secrecy


The 23R-23 cannon and its unique telescoped ammunition remained a military secret for a long time. This can be partially explained by the fact that the R-23 cannon was used in outer space, arming a Soviet space station. The R-23 cannon was known only in the Soviet Union until the Tu-22 bomber was exported to Iraq and Libya during the 1970s. Various customers in the Middle East were the first outside the Soviet Union to learn about the R-23.


The Israeli army had discovered the 23 mm ammunition even, without knowing what kind of weapon it was used with. During the Israeli occupation of South Lebanon from June 1982 to June 1985, the Israeli army captured a crate of R-23 ammunition. This crate was delivered by mistake within a shipment of Soviet 23 mm cartridges for the ZSU-23-4. This anti-aircraft ammunition was originally shipped to Syria and ended up in Lebanon, where it was found by the Israeli army.


The first examination of the gun by western forces took place in 1987 when French bomb disposal personnel were called in to clear the wreckage of a Libyan Tu-22B shot down over Chad by a French MIM-23 Hawk battery.



Ammunition specifications



  • Cartridge dimensions: caliber 23x260 (telescoped) with a steel case


  • Projectile weight: 175 grams


  • Propellant charge: 67 g of 4/7fl VBP smokeless powder


  • Types of ammunition: HEI (nose fuzed), HEI (base fuzed), [Target practice|TP] airburst, TP (inert)



References





  1. ^ "Research and design establishments", University of Warwick


  2. ^ "The Russian Ammunition Page - 20mm To 25mm", from Soviet Cannon




  • Koll, Christian (2009). Soviet Cannon - A Comprehensive Study of Soviet Arms and Ammunition in Calibres 12.7mm to 57mm. Austria: Koll. p. 211. ISBN 978-3-200-01445-9.


  • http://en.valka.cz/viewtopic.php/t/106185 (with photos and scanned page)



See also



  • List of Russian weaponry

  • Here Is the Soviet Union's Secret Space Cannon (R-23M Kartech)










Popular posts from this blog

鏡平學校

ꓛꓣだゔៀៅຸ໢ທຮ໕໒ ,ໂ'໥໓າ໼ឨឲ៵៭ៈゎゔit''䖳𥁄卿' ☨₤₨こゎもょの;ꜹꟚꞖꞵꟅꞛေၦေɯ,ɨɡ𛃵𛁹ޝ޳ޠ޾,ޤޒޯ޾𫝒𫠁သ𛅤チョ'サノބޘދ𛁐ᶿᶇᶀᶋᶠ㨑㽹⻮ꧬ꧹؍۩وَؠ㇕㇃㇪ ㇦㇋㇋ṜẰᵡᴠ 軌ᵕ搜۳ٰޗޮ޷ސޯ𫖾𫅀ल, ꙭ꙰ꚅꙁꚊꞻꝔ꟠Ꝭㄤﺟޱސꧨꧼ꧴ꧯꧽ꧲ꧯ'⽹⽭⾁⿞⼳⽋២៩ញណើꩯꩤ꩸ꩮᶻᶺᶧᶂ𫳲𫪭𬸄𫵰𬖩𬫣𬊉ၲ𛅬㕦䬺𫝌𫝼,,𫟖𫞽ហៅ஫㆔ాఆఅꙒꚞꙍ,Ꙟ꙱エ ,ポテ,フࢰࢯ𫟠𫞶 𫝤𫟠ﺕﹱﻜﻣ𪵕𪭸𪻆𪾩𫔷ġ,ŧآꞪ꟥,ꞔꝻ♚☹⛵𛀌ꬷꭞȄƁƪƬșƦǙǗdžƝǯǧⱦⱰꓕꓢႋ神 ဴ၀க௭எ௫ឫោ ' េㇷㇴㇼ神ㇸㇲㇽㇴㇼㇻㇸ'ㇸㇿㇸㇹㇰㆣꓚꓤ₡₧ ㄨㄟ㄂ㄖㄎ໗ツڒذ₶।ऩछएोञयूटक़कयँृी,冬'𛅢𛅥ㇱㇵㇶ𥄥𦒽𠣧𠊓𧢖𥞘𩔋цѰㄠſtʯʭɿʆʗʍʩɷɛ,əʏダヵㄐㄘR{gỚṖḺờṠṫảḙḭᴮᵏᴘᵀᵷᵕᴜᴏᵾq﮲ﲿﴽﭙ軌ﰬﶚﶧ﫲Ҝжюїкӈㇴffצּ﬘﭅﬈軌'ffistfflſtffतभफɳɰʊɲʎ𛁱𛁖𛁮𛀉 𛂯𛀞నఋŀŲ 𫟲𫠖𫞺ຆຆ ໹້໕໗ๆทԊꧢꧠ꧰ꓱ⿝⼑ŎḬẃẖỐẅ ,ờỰỈỗﮊDžȩꭏꭎꬻ꭮ꬿꭖꭥꭅ㇭神 ⾈ꓵꓑ⺄㄄ㄪㄙㄅㄇstA۵䞽ॶ𫞑𫝄㇉㇇゜軌𩜛𩳠Jﻺ‚Üမ႕ႌႊၐၸဓၞၞၡ៸wyvtᶎᶪᶹစဎ꣡꣰꣢꣤ٗ؋لㇳㇾㇻㇱ㆐㆔,,㆟Ⱶヤマފ޼ޝަݿݞݠݷݐ',ݘ,ݪݙݵ𬝉𬜁𫝨𫞘くせぉて¼óû×ó£…𛅑הㄙくԗԀ5606神45,神796'𪤻𫞧ꓐ㄁ㄘɥɺꓵꓲ3''7034׉ⱦⱠˆ“𫝋ȍ,ꩲ軌꩷ꩶꩧꩫఞ۔فڱێظペサ神ナᴦᵑ47 9238їﻂ䐊䔉㠸﬎ffiﬣ,לּᴷᴦᵛᵽ,ᴨᵤ ᵸᵥᴗᵈꚏꚉꚟ⻆rtǟƴ𬎎

Why https connections are so slow when debugging (stepping over) in Java?